The OG is 8 inches long, but only increases your overall length by 4 inches! But why have four inches of suppressor that aren’t being used? Well, they are being used! The long expansion chambers around the barrel allow the gas to expand differently than if the suppressor was simply 8 inches of baffles. In keeping with our motto of chasing tones, we have transformed the rifle report into a flatter, duller “thwap”, rather than a sharp “crack”.
In accomplishing our goal of bringing the overall length of the rifle + suppressor down, the OG also makes the balance of the rifle itself feel better. Keeping the weight further back makes it lighter in the hand as well as alters the center of the mass of the rifle significantly less. This makes the OG feel much better on the end of a hunting rifle.
The OG is printed in one piece from Grade 23 Titanium. The One Piece construction is patent pending, providing superior durability and performance while utilizing the flexibility of the 3D printing process.
Measures 129.5 dBA at the shooter’s ear, shot out of a 24-inch 6.5 Creedmoor firing Hornady 140 ELDM ammunition.
Titanium can be subject to strength loss at high heat. We recommend keeping your titanium suppressor below 800 degrees.
There are no barrel restrictions for standard bolt face cartridges. For short action magnum we recommend 16 inches or longer. For long action magnum we recommend 18 inches or longer.
.30 Cal
129.5 dBA at the ear
Printed from Grade 23 Titanium
One solid piece of material
Length: 8”
Width: 1.55”
Weight: 10.9 ounces
Hub: 5/8-24 direct threads (1/2-28 adapter available)
Fitment: 4” around the barrel, 4” in front of the muzzle
Max Barrel Width: Up to .750” diameter barrels
